BA-100 Base Coat and Adhesive
BA-100 is a dry powder latex-modified Portland Cement Based Product designed
for use as a base coating and adhesive for expanded polystyrene foam (ESP) and
requires only water for mixing.
Features / Benefits
Dry bagged product
Base Coat and Adhesive
Easily stored in cold climates
Mix only quantity needed
Convenient - just add water
Proprietary polymer blend
To adhere EPS board to substrate approximately 50-70 sf
As a base coat to imbed fiberglass mesh 90-110 sf
As a leveling coat varies upon application and technique
BA-100 is designed to coat and adhesive EPS boards as well as moldings and
cornice. Can be used over stucco - concrete - concrete block - unglazed brick -
fiber mat-faced gypsum sheathing - exterior grade gypsum sheathing - cement
board - masonry (clean and unpainted) - poured in place concrete free from
Surface must be clean, dry, structurally sound, and free from dirt, grease or
coatings that may inhibit adhesion. Temperature must be 40 degrees or higher for
a period of 24 hours after application.
Harmful if swallowed. Causes moderate eye irritation. Prolonged skin contact may cause irritation. Wash thoroughly after handling. In case of eye contact flush immediately with cool water. If skin or eye irritation persists seek medical assistance.
The manufacturer warrants this properly handled and installed product to be free from manufacturing defects from date of purchase for a period of five years.
If it is shown that the product is defective when installed by a competent installer / applicator, the manufacturer’s liability under this warranty is to supply replacement product. There are no other warranties expressed or implied and the manufacturer or manufacturer’s representative shall determine the remedies. We make no other warranties and expressly disclaim any warranties of merchantability or fitness for a particular purpose. See full warranty schedule in our product literature submittal package.
Protect from freezing. Do not apply in temperatures above 110-F or below 38 F. The ambient and surface temperature must remain within these temperature ranges until fully cured (minimum 24 hours). Protect all work from inclement weather until fully cured.
Do not add any other materials to this product without written permission from the manufacturer.
This is not a finished product and must have a finish layer applied.
Use fresh water to clean tools or droppings before product dries.
Stucco Depot llc
150 North Plains Industrial Rd.
Wallingford, CT 06492